ผลการค้นหา

Waste minimization

แปลว่า(Environmental Engineering) The elimination or reduction of a waste prior to its generation. This is accomplished by process changes rather than waste treatment methods.

Bed-In

แปลว่า(english) Method whereby drag may be rammed in the pit or flask without necessity of rolling over. Process used in production of heavy castings.

Task set

แปลว่า(Software Engineering) a collection fo software engineering tasks that are required to complete an activity or action that is part of a software process framework

Work flow

แปลว่า(Software Engineering) the sequence of tasks that are required to accomplish some activity or action; often (but not always) used in conjunction with software process models

Baseline

แปลว่า(Software Engineering) a point at which some deliverable produced during the software engineering process is put under formal change contro เส้นอ้างอิง ใช้สำหรับการวางผัง หรือการสำรวจ

Batch Anneal

แปลว่า(english) The process by which a large, stationary stack of steel coils (4 coils high) is subjected to a long heat-treating cycle. This process enables the cold-rolled sheet to fully recrystallize into the softest possible product conforming to customer specifications. Controlling the recrystallization process makes a fine-grained microstructure easy to obtain, and minimizes the tendencies for retention of directional properties of the rolled steel which could produce undesirable shapes in the stamping of a cylindrical part such as a can. Also see Anneal and Continuous Anneal.

Back End

แปลว่า(english) 1) Usually refers to the entry end of process lines. 2) The outside lap 2) of the produced coil, or the inside lap of the consumed coil.

Site remediation

แปลว่า(Environmental Engineering) The process of cleaning up a hazardous waste disposal site that has either been abandoned or that those responsible either refuse to cleanup or are financially unable to cleanup.

Bright Drawing

แปลว่า(english) The process of drawing hot rolled steel through a die to impart close dimensional tolerances, a bright scale free surface and improved mechanical properties. The product is termed bright steel.

Bath Annealing

แปลว่า(english) Is immersion is a liquid bath (such as molten lead or fused salts) held at an assigned temperature-when a lead bath is used, the process is known as lead annealing.

Burn

แปลว่า(english) 1) Process of cutting metal by a stream of fuel and oxygen, 2) to permanently damage a metal or alloy by heating to cause either incipient melting or intergranular oxidation.

Blow Down

แปลว่า(english) Process that rids boiler feed water of solids and maintains the proper chemical balance of the feed water. Blow down can also be used to rid drum(s) of excess water.