ผลการค้นหา

Ball Burnishing

แปลว่า(english) A method of obtaining a high luster on small parts by rotating them in a wooden-lined barrel with water, burnishing soap, and stainless steel shot.

Acid Steel

แปลว่า(english) Steel melted in a furnace with an acid bottom and lining and under a slag containing an excess of an acid substance such as silica.

Work flow

แปลว่า(Software Engineering) the sequence of tasks that are required to accomplish some activity or action; often (but not always) used in conjunction with software process models

Acid

แปลว่า(english) 1) A solution or liquid with a pH less than 7, 2) term applied to slags, refractors, and minerals containing a high percentage of silica.

Toxicity

แปลว่า(Environmental Engineering) A U.S. EPA hazardous waste characteristic defined with a rigorous test procedure, the TCLP (for Toxicity Characteristic Leaching Procedure). In the procedure, a waste is extracted for 24 hours with an acetic acid solution. The acid extract is then analyzed for the presence of any of the contaminants listed in the procedure.

Amino acid

แปลว่า(Environmental Engineering) A functional group which consists of a carbon with a carboxylic acid, "-COOH" and an amine, "-NH2." These compounds are the building blocks for proteins.

Bearing Load

แปลว่า(english) A compressive load supported by a member, usually a tube or collar, along a line where contact is made with a pin, rivet, axle, or shaft.

A Sheet Metal Screw

แปลว่า(english) Sheet metal screws with (a) sharp-pointed ends; and (b) fewer threads per inch than type AB screws; and (c) deeper threads with bettere gripping power than type AB. The industrial Fasteners Institue incorrectly labes type A an “obsolete” thread though it is universally preferred in 18-8 stainless over type AB, especially by the marine industry.

Task analysis

แปลว่า(Software Engineering) a software engineering action that is conducted as part of user interface design; intended to better understand how a user is to interact with a system

Basic Steel

แปลว่า(english) Steel melted in a furnace with a basic bottom and lining and under a slag containing an excess of a basic substance such as magnesia or lime.

Accordion Reed Steel

แปลว่า(english) Hardened, tempered, polished and blued or yellow flat steel with dressed edges. Carbon content about 1.00. Material has to possess good flatness, uniform hardness and high elasticity.

Baller Stick

แปลว่า(english) Octagon-shaped wooden stick approximately 5' long. This stick is used in the baller area, to change burr mashers, to start a coil with a large ID, etc.