ผลการค้นหา

pick up speed

แปลว่าค่อยๆ เร่งความเร็ว (ของเครื่องยนต์) ให้สูงขึ้น

backed-up

แปลว่า(การพิมพ์) แผ่นกระดาษที่พิมพ์ทั้งสองหน้า backed - up erong = แสดงว่าพิมพ์ผิด

Back-up Balance

แปลว่า(english) Cylinders that supply the force used to hold the back-up rolls up in place.

Burr Mashers

แปลว่า(english) Devices used to remove build up on edge of strip after the slitting process.

Zirconia

แปลว่า(english) ZrO2 an acid refractory up to 2500 B0C (4532 B0F) having good thermal shock resistance and low electrical resistively.

In situ treatment

แปลว่า(Environmental Engineering) Treatment of a waste in place, as opposed to pumping or digging the waste up and then treating it.

Burnt Rubber

แปลว่า(english) Small or large black spots that generally show up on surface and are generally caused by pickling steel too hot.

Bust Coil

แปลว่า(english) Coils removed from the off-gauge reel. The BUST (build up side trimmer) coil contains defects (gauge variation and quality defects) and off-spec widths.

Cement Gel

แปลว่า(Concrete Engineering) The colloidal gel (glue like) material that makes up the major portion of the porous mass of which hydrated cement paste is composed.

Site remediation

แปลว่า(Environmental Engineering) The process of cleaning up a hazardous waste disposal site that has either been abandoned or that those responsible either refuse to cleanup or are financially unable to cleanup.

Breaker

แปลว่า(english) Uncoiler rolls through which the strip passes; composed of a mandrel and leveling rolls which unwind the strip prior to processing through the Pickler. Breaker rolls assist in breaking up the Hot Mill surface scale.

Z-Mill

แปลว่า(english) The full name for z-mill is Sendzimir mill. A Z-mill operates with a very small diameter work roll, normally about 2 inches, backed up by a number of rolls in a pyramid-shaped stack. This roll set up allows you to exert extremely high forces through the work roll and yet keep the work roll from extreme flexing. The take-up roll on the Z-Mill also exerts a tension on the coil as it comes through the mill. The combination of high pressure and tension makes the mill capable of rolling material thin and flat.