ผลการค้นหา

pick at* *pick at *pick at*
คำศัพท์ช่างภาษาอังกฤษ - ไทยคำศัพท์/สำนวน ทั้งหมดบทความ
ค้นเจอ 80 รายการ

คำศัพท์ช่างภาษาอังกฤษ - ไทยที่เกี่ยวข้องกับ "pick at"

คลิกที่แต่ละคำเพื่อดูรายละเอียด

Strain:

(english) The intensity of deformation at a point in an object. See normal strain and shear strain.

Blue Brittleness 2

(english) Reduced ductility occurring as a result of strain aging, when certain ferrous alloys are worked between 300 and 700 (degrees) F. This phenomenon may be observed at the working temperature or subsequently at lower temperatures.

Blast Furnace 2

(english) A vertical shaft type smelting furnace in which an air blast is used, usually hot, for producing pih iron. The furnace is continuous in operation using iron ore, coke, and limestone as raw materials which are charged at the top while the molten iron and slag are collected at the bottom and are tapped out at intervals.

Adsorption

(Environmental Engineering) A surface phenomena in which a solute (soluble material) concentrates or collects at a surface (the adsorbent).

Paper prototype

(Software Engineering) a paper representation of an application (e.g., story boards that describe the interaction at a human interface)

Boiler

(english) A closed vessel in which water, is transformed into steam at a given pressure and temperature under controlled conditions.

Anoxic process

(Environmental Engineering) A process which occurs only at very low levels of molecular oxygen or in the absence of molecular oxygen.

Ductility:

(english) Ductility generally refers to the amount of inelastic deformation which a material or structure experiences before complete failure. Quantitatively, ductility can be defined as the ratio of the total displacement or strain at failure, divided by the displacement or strain at the elastic limit.

Source reduction

(Environmental Engineering) The elimination or reduction of the waste at the source by modification of the actual process which produces the waste.

Butt end

(english) The residual portion of an extrusion billet that is not forced through the die at the end of the extrusion cycle.

Siting

(Environmental Engineering) Obtaining government (federal, state, and local) permission to construct an environmental processing, treatment, or disposal facility at a given site.

Rebound

(Concrete Engineering) Wet shotcrete or sand and cement which bounces away from a surface again at which pneumatically applied mortar is being projected.

 ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด