ผลการค้นหา

Colloids

แปลว่า(Environmental Engineering) Small particles which have a negligible settling velocity. These particles have a very small mass so gravitational force is low compared to surface frictional forces. Typical colloidal sizes range from 10-3 mm to 1 mm.

Dump

แปลว่า(Environmental Engineering) An illegal and uncontrolled area where wastes have been placed on or in the ground. See Landfill.

Bedding

แปลว่า(english) Sinking a pattern down into the sand to the desired position and ramming the sand around it.

Brite

แปลว่า(english) 1) Regular galvanize coating (not minimized spangle or JP). 2) Rolls that have no grit; smooth finish on surface of steel.

Ultimate disposal

แปลว่า(Environmental Engineering) The process of returning residuals back to the environment in a form which will have the minimal or reduced negative environmental impacts.

Software safety

แปลว่า(Software Engineering) an SQA activity that focuses on the identification and assessment of potential hazard that may have a negative impact on the operation of software

Synergism is the act of working together

แปลว่า(Environmental Engineering) Two chemicals which are synergistic have a greater effect together than the sum of their individual effects. The effect can be either positive or negative.

A Coatings

แปลว่า(English) Coatings on hot-dipped galvanized steels processed to convert the coating completely to zinc-iron alloys; dull gray in appearance, have no spangle, and after proper preparation, are well suited for painting.

Yield stress:

แปลว่า(english) A material loaded beyond its yield stress, no longer exhibits linear elastic behavior. Metals, particularly mild steel, generally have a very well defined yield stress compared to other materials. Yield stress is sometimes called yield strength.

Pin support:

แปลว่า(english) In two dimensions, a pin support restrains two translation degrees of freedom but does not restrain rotation. When considering reaction forces, a pin support is usually considered to have two force components: one each about the x and y axes respectively.

Blow Back

แปลว่า(english) A coating defect consisting of a lower coating film weight on the bottom of the coated sheet caused by high velocity air in the oven. Blow back usually occurs with high solids coatings which have little solvent to evaporate and "set" the film.

Back Rake

แปลว่า(english) The angular surface ground back from the cutting edge of cutting tools. On lathe cutting tools. The rake is positive if the face slopws down from the cutting edge toward the shank, and negative if the face sloopes upward toward the shank.