ผลการค้นหา

Statically equivalent:

แปลว่า(english) Two force systems are statically equivalent when their resultants are equal. Physically, this means that the force systems tend to impart the same motion when applied to an object; note that the distribution of resulting internal forces in the object may be different.

Blow Back

แปลว่า(english) A coating defect consisting of a lower coating film weight on the bottom of the coated sheet caused by high velocity air in the oven. Blow back usually occurs with high solids coatings which have little solvent to evaporate and "set" the film.

Wagner Fineness

แปลว่า(Concrete Engineering) The fineness of materials such as portland cement expressed as total surface area in centimeters per gram as determined by the Wagner turbidimeter apparatus and procedure.

B Elevation

แปลว่า(english) The bottom level of the boiler firebox where two oil guns are located. The oil guns are used if the boiler needs extra steam while on oil fire.

Stress:

แปลว่า(english) The intensity of internal force acting at a point in an object. Stress is measured in units of force per area. See shear stress and normal stress.

Body-Centered

แปลว่า(english) Having the equivalent lattice points at the corners of the unit cell, and at its center; sometimes called centered, or space-centered.

Landfilling

แปลว่า(Environmental Engineering) The placement of wastes into the land under controlled conditions to minimize their migration or effect on the surrounding environment.

Bloom 2

แปลว่า(english) A semi-finished hot rolled product, rectangular in cross section, produced on a blooming mill. For iron and steel, the width is not more than twice the thickness, and the cross-sectional area is usually not less than 36 sq. in. Iron and steel blooms are sometimes made by forging.

Banding

แปลว่า(english) Inhomogeneous distribution of alloying elements or phases aligned in filaments or plates parallel to the direction of working.

Dump

แปลว่า(Environmental Engineering) An illegal and uncontrolled area where wastes have been placed on or in the ground. See Landfill.

Backer (back-up plate)

แปลว่า(english) A “tool” or reinforcing part, which presses against the outer surface of an extrusion die, supporting it against the pressure of the extruding metal. The backer has an opening larger than the die aperture, allowing the extruded product to emerge without marring its soft surface.

At the Contractor’s Cost

แปลว่าด้วยค่าใช้จ่ายของผู้รับจ้างเอง