ผลการค้นหา

Brown Sharp Gages

แปลว่า(english) A standard series of sizes refered to by numbers, in which the diameter of wire or thickness of sheet metal is generally produced and which is used in the manufacture of brass, bronze, copper, copper-base alloys and aluminum. These gage numbers have a definite relationship to each other. In this system, the decimal thickness is reduced by 50% every six gage numbers- while temper is expressed by the number of B&S gage numbers as cold reduced in thickness from previous annealing. For each B&S gage number in thickness reduction, where is assigned a hardness value of 1/4 hard.

Procaryotic organisms

แปลว่า(Environmental Engineering) Organisms which do not have a cellular membrane.

Bacteria

แปลว่า(Environmental Engineering) One celled microorganisms which do not have a nuclear membrane.

spokeshave

แปลว่าเครื่องมือของช่างไม้ มีใบมีดอยู่ตรงกลาง สำหรับไสขอบโค้ง

A Coatings

แปลว่า(English) Coatings on hot-dipped galvanized steels processed to convert the coating completely to zinc-iron alloys; dull gray in appearance, have no spangle, and after proper preparation, are well suited for painting.

Synergism is the act of working together

แปลว่า(Environmental Engineering) Two chemicals which are synergistic have a greater effect together than the sum of their individual effects. The effect can be either positive or negative.

Change control authority (CCA)

แปลว่า(Software Engineering) the person(s) who have responsibility for deciding whether a change is to be made

Brite

แปลว่า(english) 1) Regular galvanize coating (not minimized spangle or JP). 2) Rolls that have no grit; smooth finish on surface of steel.

Dump

แปลว่า(Environmental Engineering) An illegal and uncontrolled area where wastes have been placed on or in the ground. See Landfill.

Brazing

แปลว่า(english) Joining metals by fusion of nonferrous alloys that have melting points above 800 F (425C), but lower than those of the metals being joined. May be accomplished by a torch. Filler metal is ordinarily in rod form in torch brazing; whereas in furnace and dip brazing the work material is first assembled and the filler metal may then be applied as wire, washers, clips, bands, or may be bonded, as in brazing sheet.