ผลการค้นหา

Denitrification

แปลว่า(Environmental Engineering) The anoxic biological conversion of nitrate to nitrogen gas. It occurs naturally in surface waters low in oxygen, and it can be engineered in wastewater treatment systems.

Discrete settling

แปลว่า(Environmental Engineering) Settling in which individual particles settle independently, neither agglomerating or interfering with the settling of the other particles present. This occurs in waters with a low concentration of particles.

Billet container

แปลว่า(english) The part of the extrusion press into which the billet to be extruded is placed.

Banded Structure

แปลว่า(english) Appearance of a metal showing parallel bands in the direction of rolling or working

Blister

แปลว่า(english) 1) Coating defect consisting of the formation of bubbles in a coating, which appear as hemispherical elevations. The blisters are hollow, and are usually caused by entrapped air or solvent. 2) A raised spot on the surface on the surface of metal due to expansion of gas which causes a subsurface metal separation such as inclusions and small laminations.

Accm

แปลว่า(english) In hypereutectoid steel, the temperature at which cementite goes into complete solution with austenite.

Give the right of access to the site

แปลว่าให้สิทธิในการเข้าพื้นที่ก่อสร้าง

Cyclomatic complexity

แปลว่า(Software Engineering) a measure of the logical complexity of an algorithm, used in white-box testing

Nitrogenous oxygen demand (NOD)

แปลว่า(Environmental Engineering) The amount of oxygen required to oxidize any ammonia present in a water.

Blast Furnace Slag

แปลว่า(Concrete Engineering) A non-metallic waste product developed in the manufacture of pig iron, consisting basically of a mixture of lime, silica and alumina, the same oxides that make up portland cement, but not in the same proportions or forms. It is used both in the manufacture of portland blast furnace slag cement and as an aggregate for lightweight concrete.

Butt end

แปลว่า(english) The residual portion of an extrusion billet that is not forced through the die at the end of the extrusion cycle.

Adsorption Water

แปลว่า(Concrete Engineering) Water held on surfaces in a material by either physical and/or chemical forces.