ผลการค้นหา

ค้นเจอ 287 รายการ

Abrasive Wheels

(english) Wheels of a hard abrasive, such as Carborundum used for grinding.

Blast Furnace Slag

(Concrete Engineering) A non-metallic waste product developed in the manufacture of pig iron, consisting basically of a mixture of lime, silica and alumina, the same oxides that make up portland cement, but not in the same proportions or forms. It is used both in the manufacture of portland blast furnace slag cement and as an aggregate for lightweight concrete.

Gillmore Needle

(Concrete Engineering) A device used in determining time of setting of hydraulic cement, described in ASTM 0 266. Gradation The sizing of granular materials; for concrete materials, usually expressed in terms of cumulative percentages larger or smaller than each of a series of sieve openings or the percentages between certain ranges of sieve openings.

Burnt Rubber

(english) Small or large black spots that generally show up on surface and are generally caused by pickling steel too hot.

fusee

สายชนวน

dwelling house

เคหะสถาน

Merger Clause

ข้อสัญญาร่วมค้า

Ottawa Sand

(Concrete Engineering) A sand used as a standard in testing hydraulic cements by means of mortar test specimens. Sand is produced by processing silica rock particles obtained by hydraulic mining of the orthoquartzite situated in open-pit deposits near Ottawa, Illinois; naturally rounded grains of nearly pure quartz.

store-house

โรงเก็บของ, โกดัง

Bars

(english) A relatively long straight, rigid piece pf metal; long steel products rolled from billets into such shapes as squares,rectangles, rounds,angles,channels,hexagons,and tees. In steel, “merchant bars” include rounds,flats,angles,squares,and channels that are used by fabricators to manufacture a wide variety of products such as furniture,stair railings and farm equipment. Concrete reinforcing bar (rebar) is used to strengthen concrete in highways,bridges and buildings.

Inelastic:

(english) Not surprisingly, the opposite of elastic. A deformation of a structure or material under load is described as inelastic when the deformation remains after the load is removed. The term plastic is often used with the same meaning.

Blowhole

(english) A defect in a casting caused by trapped steam or gas.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด