ผลการค้นหา

Construction Joint

แปลว่า(Concrete Engineering) The contact between the placed concrete and concrete surfaces, against or upon which concrete is to be placed and to which new concrete is to adhere, that has become so rigid that the new concrete cannot be incorporated integrally by vibration with that previously placed. Unformed construction joints are horizontally placed or nearly so.

Moment of inertia (I):

แปลว่า(english) Moment of inertia has two distinct but related meanings: 1) it is a property of a an object relating to the magnitude of the moment required to rotate the object and overcome its inertia. 2) A property of a two dimensional cross section shape with respect to an axis, usually an axis through the centroid of the shape.

Clarifier (sedimentation basin)

แปลว่า(Environmental Engineering) A tank in which quiescent settling occurs, allowing solid particles suspended in the water to agglomerate and settle to the bottom of the tank. The solids resulting from the settling being removed as a sludge.

Bedding

แปลว่า(english) Sinking a pattern down into the sand to the desired position and ramming the sand around it.

Bridle

แปลว่า(english) A set of rolls used to maintain tension on the strip as it goes through the line.

User

แปลว่า(Software Engineering) the person who actually used to software or the product that has software embedded within it

Runoff

แปลว่า(Environmental Engineering) The water that flows overland to lakes or streams during and shortly after a precipitation event.

Activation

แปลว่า(english) The changing of the passive surface of a metal to a chemically active state. Contrast with passivation.

Load testing

แปลว่า(Software Engineering) a testing task that determines how software (often a WebApp) will respond to various loading conditions

Cohesion

แปลว่า(Software Engineering) an informal measure of the degree to which a software component implements a single, focused function

Bend Test

แปลว่า(english) Various tests which is used to ascertain the toughness and ductility of a metal product, in which the material is bent around its axis and/ or around an outside radius. A complete test might specify such a bend to be both with and against the direction of grain. For testing, samples should be edge filed to remove burrs and any edgewise cracks resulting from slitting or shearing. If a vice is to be employed, then you must line the jaws with some soft metal, to permit a flow of the metal in the piece being tested.

Colloids

แปลว่า(Environmental Engineering) Small particles which have a negligible settling velocity. These particles have a very small mass so gravitational force is low compared to surface frictional forces. Typical colloidal sizes range from 10-3 mm to 1 mm.