ผลการค้นหา

ค้นเจอ 341 รายการ

Water Vapor Pressure

(Concrete Engineering) The pressure exerted by water vapor. Air that contains higher amounts of water vapor exerts a higher vapor pressure than air which has a lower amount of has a higher water vapor pressure In concrete water vapor pressure is calculated by the difference between the vapor pressure of the concrete and the ambient relative humidity and temperature and in contact with the soil. that is calculated by; based upon relative humidity and temperature. The greater the difference between the water vapor and ambient humidity and temperature, in degrees Fahrenheit. the greater the water vapor pressure exerted.

Ion exchange

(Environmental Engineering) An adsorption process in which one ion is exchanged for another ion of like charge. There is an equivalence of exchanged charge.

Recycling

(Environmental Engineering) The recovery and reuse of a product which would otherwise be thrown away.

Bearing Load

(english) A compressive load supported by a member, usually a tube or collar, along a line where contact is made with a pin, rivet, axle, or shaft.

BACK-UP RING

(english) A fabric or plastic device that is used with an o-ring or other gasket to prevent extrusion of the o-ring or gasket into an adjacent space or crevice

windscreen weather strip

กันสาดหรือกระบังหน้ากระจกหน้ารถ

medium washer

แหวนประเก็นขนาดกลาง

Basic Oxygen Process 2

(english) A steel making process wherein oxygen of the highest purity is blown onto the surface of a bath of molten iron contained in a basic lined and ladle shaped vessel. The melting cycle duration is extremely short with quality comparable to Open Hearth Steel.

Gas stripping

(Environmental Engineering) Gas transfer of an undesirable gas from a water stream to the atmosphere.

Agglomerating Processes

(english) "Fine particles of limestone (flux) and iron ore are difficult to handle and transport because of dusting and decomposition, so the powdery material usually is processed into larger pieces. The raw material's properties determine the technique that is used by mills. 1) SINTER Baked particles that stick together in roughly one-inch chunks. Normally used for iron ore dust collected from the blast furnaces. 2) PELLETS Iron ore or limestone particles are rolled into little balls in a balling drum and hardened by heat. 3) BRIQUETTES Small lumps are formed by pressing material together. Hot Iron Briquetting (HBI) is a concentrated iron ore substitute for scrap for use in electric furnaces.

Adeline Steelmaking Process

(english) Method of producing a precision casting of steel or steel alloys using aluminolthermic process and lost wax, followed by centrifugal action.

exothermic

ระบายความร้อนออกไป, ขับความร้อนออกไป

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด