ผลการค้นหา

Electronegativity

แปลว่า(Environmental Engineering) The potential of an atom to attract electrons when the atom is bonded in a compound. The scale is 0 to 4 with 0 being the most electropositive (low attraction) and 4 being the most electronegative (high attraction).

Interface design

แปลว่า(Software Engineering) a software engineering action that establishes the structure and workflow for a user interface; follows three "golden rules:" place the user in control, reduce the user's memory leoad, make the interface consistent.

Bolster (die block)

แปลว่า(english) A “tool” or reinforcing part which supports the backer-which, in turn, supports an extruding die against the pressure of extrusion.

Cold Joint

แปลว่า(Concrete Engineering) A visible lineation which forms when the placement of concrete is delayed. The concrete in place hardens prior to the next placement of concrete against it.

Block Off

แปลว่า(english) 1) Wooden separators which are used at both the bottom of a lift and between IPM's (bundles) of a lift. 2) The act of placing 4x4s between the lifts in the piler's box.

Attached growth reactor

แปลว่า(Environmental Engineering) A reactor in which the microorganisms are attached to engineered surfaces within the reactor. Examples of attached growth reactors are the trickling filter and the rotating biological contactor. See suspended growth reactor.

Flexibility:

แปลว่า(english) Flexibility is the inverse of stiffness. When a force is applied to a structure, there is a displacement in the direction of the force; flexibility is the ratio of the displacement divided by the force. High flexibility means that a small load produces a large displacement.

Air Entraining Agent

แปลว่า(Concrete Engineering) An addition for hydraulic cement, or an admixture for concrete or mortar which entrains air in the form of minute bubbles in the concrete or mortar during mixing.

Species

แปลว่า(Environmental Engineering) In chemistry, an ion or molecule in solution.

Debugging

แปลว่า(Software Engineering) the activity associated with finding and correcting an error or defect - a lack of conformance to requirements found in the software after delivery to the customer

Back Rake

แปลว่า(english) The angular surface ground back from the cutting edge of cutting tools. On lathe cutting tools. The rake is positive if the face slopws down from the cutting edge toward the shank, and negative if the face sloopes upward toward the shank.

Inertia:

แปลว่า(english) The tendency of an object at rest to remain at rest, and of an object in motion to remain in motion.