ตัวกรองผลการค้นหา
คลิกที่แต่ละคำเพื่อดูรายละเอียด
ค่าแห่งกฎของแอมแปร์ซึ่งกำหนดขึ้นโดย International Congress of Electricians ที่ถือเป็นมาตรฐานสากลในชิคาโก เมื่อ ปี ค.ศ.1893
ปริมาณฝนสะสม : ดู [[rainfall]], [[accumulated]]
(Software Engineering) a point at which some deliverable produced during the software engineering process is put under formal change contro เส้นอ้างอิง ใช้สำหรับการวางผัง หรือการสำรวจ
ปริมาณน้ำฝนที่ตกมาก่อนแล้ว : ดู [[rainfall]], [[antecedent]]
(english) Is immersion is a liquid bath (such as molten lead or fused salts) held at an assigned temperature-when a lead bath is used, the process is known as lead annealing.
(Environmental Engineering) Gas transfer of an undesirable gas from a water stream to the atmosphere.
(english) "Fine particles of limestone (flux) and iron ore are difficult to handle and transport because of dusting and decomposition, so the powdery material usually is processed into larger pieces. The raw material's properties determine the technique that is used by mills. 1) SINTER Baked particles that stick together in roughly one-inch chunks. Normally used for iron ore dust collected from the blast furnaces. 2) PELLETS Iron ore or limestone particles are rolled into little balls in a balling drum and hardened by heat. 3) BRIQUETTES Small lumps are formed by pressing material together. Hot Iron Briquetting (HBI) is a concentrated iron ore substitute for scrap for use in electric furnaces.
(Software Engineering) an object-oriented modeling method that identifies and organizes classes are are relevant to a system
(english) A pen or ink line drawing reproduced (printed) on sensitized paper by direct exposure.
(english) Method of producing a precision casting of steel or steel alloys using aluminolthermic process and lost wax, followed by centrifugal action.
(Software Engineering) creates representation of the data and architecture
(english) In two dimensions, a pin support restrains two translation degrees of freedom but does not restrain rotation. When considering reaction forces, a pin support is usually considered to have two force components: one each about the x and y axes respectively.