ผลการค้นหา

Brown Sharp Gages

แปลว่า(english) A standard series of sizes refered to by numbers, in which the diameter of wire or thickness of sheet metal is generally produced and which is used in the manufacture of brass, bronze, copper, copper-base alloys and aluminum. These gage numbers have a definite relationship to each other. In this system, the decimal thickness is reduced by 50% every six gage numbers- while temper is expressed by the number of B&S gage numbers as cold reduced in thickness from previous annealing. For each B&S gage number in thickness reduction, where is assigned a hardness value of 1/4 hard.

Electronegativity

แปลว่า(Environmental Engineering) The potential of an atom to attract electrons when the atom is bonded in a compound. The scale is 0 to 4 with 0 being the most electropositive (low attraction) and 4 being the most electronegative (high attraction).

Selective testing

แปลว่า(Software Engineering) testing only a selected set of program paths and data inputs

Total solids

แปลว่า(Environmental Engineering) (TS) is the amount of organic and inorganic matter which is contained in a water.

Slip Form

แปลว่า(Concrete Engineering) A form which is raised or pulled as concrete is placed; may move vertically to form wails, stacks, bins or silos, usually of uniform cross section from bottom to top; or a generally horizontal direction to lay concrete evenly for highways, on slopes and inverts of canals, tunnels, and siphons.

Primary standards

แปลว่า(Environmental Engineering) Required drinking water quality standards related directly to human health. These standards are required and enforceable by the U.S. EPA. See secondary standards.

Risk Management and Monitoring Plan (RMMP)

แปลว่า(Software Engineering) a plan for mitigating, monitoring and managing risks

Wagner Fineness

แปลว่า(Concrete Engineering) The fineness of materials such as portland cement expressed as total surface area in centimeters per gram as determined by the Wagner turbidimeter apparatus and procedure.

Modulus of elasticity:

แปลว่า(english) The proportional constant between stress and strain for material with linear elastic behavior: calculated as stress divided by strain. Modulus of elasticity can be interpreted as the slope of the stress-strain graph. It is usually denoted as E, sometimes known as Young's Modulus Y, or E-Modulus.

Blister

แปลว่า(english) 1) Coating defect consisting of the formation of bubbles in a coating, which appear as hemispherical elevations. The blisters are hollow, and are usually caused by entrapped air or solvent. 2) A raised spot on the surface on the surface of metal due to expansion of gas which causes a subsurface metal separation such as inclusions and small laminations.

Consistency

แปลว่า(Concrete Engineering) The degree of plasticity of fresh concrete or mortar The normal measure of consistency is slump for concrete and flow for mortar.

Brittle Inter-metallic Layer

แปลว่า(english) An iron-zinc alloy layer formed between the steel substrate and the free zinc of galvanized coatings.