ผลการค้นหา

ค้นเจอ 48 รายการ

หรือคุณกำลังค้นหา sheet, sheeting, sheet

A Sheet Metal Screw

(english) Sheet metal screws with (a) sharp-pointed ends; and (b) fewer threads per inch than type AB screws; and (c) deeper threads with bettere gripping power than type AB. The industrial Fasteners Institue incorrectly labes type A an “obsolete” thread though it is universally preferred in 18-8 stainless over type AB, especially by the marine industry.

Bi-Coil

(english) Also BY-COIL. Tin Mill term. Customers buy "by coil" or "bi-coil" rather than cut sheets

louer sheet

บานเกร็ด

galvanized sheets

แผ่นสังกะสี ซึ่งมีขนาดกว้าง 20 ถึง 30 นิ้ว และความยาว 66 นิ้ว

asbestos cement sheet

กระเบื้องซีเมนต์ใยหินแผ่นเรียบ

stencil paper , waxed sheet

กระดาษไข

sheet metal gauge

เครื่องมือที่ใช้สำหรับวัดความหนาบางของแผ่นโลหะ

Blanking

(english) An early step in preparing flat-rolled steel for use by an end user. A blank is a section of sheet that has the same outer dimensions as a specified part (such as a car door or hood) but that has not yet been stamped. Steel processors may offer blanking for their customers to reduce their labor and transportation costs; excess steel can be trimmed prior to shipment.

Bamboo Grain Structure

(english) A structure in wire or sheet in which the boundaries of the grains tend to be aligned normal to the long axis and to extend completely through the thickness.

Beading

(english) Raising a ridge on sheet metal

aluminium sheet

แผ่นอลูมิเนียม

Brown Sharp Gages

(english) A standard series of sizes refered to by numbers, in which the diameter of wire or thickness of sheet metal is generally produced and which is used in the manufacture of brass, bronze, copper, copper-base alloys and aluminum. These gage numbers have a definite relationship to each other. In this system, the decimal thickness is reduced by 50% every six gage numbers- while temper is expressed by the number of B&S gage numbers as cold reduced in thickness from previous annealing. For each B&S gage number in thickness reduction, where is assigned a hardness value of 1/4 hard.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด